National Electrical Code Information and Discussion

Probably so, http://en.wikipedia.org/wiki/The_Ropers

Greg is talking about another person with that name who was active on Prodigy in the 90’s where we discussed the NEC. :slight_smile:

That was Ryan Jackson?

That would make him 10 or 11 years old then, when we did DOS at 96 bps on Prodigy! Where’s the Caper?

Roper was SO much cooler than Furley! Much as I love Don Knotts.

Caper is still working in NJ. He pops up on ECN occasionally.

Please where I can find the NEC code for overhead electrical service entry clearances.

What specifically are you looking for? Clearances are in 230.24 of the NEC. Swimming pools, 680.8.

http://www.electri-pedia.net/ServiceHeight.html

The CodeCheck book has a nice illustration of these clearances in it. I got mine at Borders but have seen them at Home Depot as well, along with the usual online book sources.

Al in TN

You might consider purchasing a National Electrical Code Book from NFPA.org as a good start.

The NEC and UL and product manufactures insist that 12ga wires be wraped around the screw. 14 ga wire can be speed wired by push-in method (UL approved). As a master elec. i don’t care for that tiney sheetmetal connection in the devise, esp in heavy loads. AS an Elec. inspector i had to pass because the manufacturer had that product “listed” for that technique.

Bill S
master elec./ State elec. inspector