Originally Posted By: bgraham
This post was automatically imported from our archived forum.
http://www.nachi.org/bbsystem/usrimages/P/PB050131.JPG ]
http://www.nachi.org/bbsystem/usrimages/P/PB050131.JPG ]
Originally Posted By: bking
This post was automatically imported from our archived forum.
If a non-vented gas log set does not have a placard stating that it is approved for no vent then I report it.
Also report any gas logs in bedrooms. Vented may be allowed in bedrooms in some areas but for my purposes they are not recommended. The reason is that most people will not provide an air source as the owners manual states.
Originally Posted By: jsieg
This post was automatically imported from our archived forum.
I personally don’t like the use of copper for gas lines… should be Black Pipe.
I know soft copper in rolls are sold for gas supply but not rigid copper. In either case copper is too soft of a metal to be using near a flame or high heat source. Copper becomes soft, expansion & contraction, if the fitting joint doesn't leak now I'm sure it will.
I bet it has leaked recently looking at all the pipe dope (yes, with that much a dope must have installed the fitting).
Originally Posted By: jsieg
This post was automatically imported from our archived forum.
OH, don’t forget that the hole that was made to run the pipe through the FIRE WALL. The fireplace has lost it’s integrity. That opening should be sealed. The fireplace is now gas ignition but the house is a wood burning bon fire.
Originally Posted By: dvalley
This post was automatically imported from our archived forum.
The question was…Unvented fireplace, Right?
--
David Valley
MAB Member
Massachusetts Certified Home Inspections
http://www.masscertified.com
"Some cause happiness wherever they go; others, whenever they go."
Originally Posted By: rcooke
This post was automatically imported from our archived forum.
Never approved for Canada.
I agree I would not have one under any circumstances.
–
Roy Cooke Sr.
http://Royshomeinspection.com
Originally Posted By: Joe Funderburk
This post was automatically imported from our archived forum.
On a similar note, what about this piping with a plastic covering over it? Seems illogical to have plastic coated pipe in a fire place.
[ Image: http://www.nachi.org/bbsystem/usrimages/1/110405_021.jpg ]
--
Thanks,
Joe Funderburk
York County, SC
Alpha & Omega Home Inspection, LLC
jfunderburk@aohomeinspection.com
www.aohomeinspection.com
Originally Posted By: jsieg
This post was automatically imported from our archived forum.
I don’t like it but then again I don’t know what the manufacture says about it… for that matter not that we are code inspectors does anyone know if there is a code dealing with gas fireplaces
I think I would note it in the report that before, after & during using of the fireplace to inspect gas line coating for burnt or scorched coating. if it looks harmed in any stop using fireplace until having a licensed plumbing & heating person inspecting damages.
Originally Posted By: rcooke
This post was automatically imported from our archived forum.
| jsieg wrote: |
| I don't like it but then again I don't know what the manufacture says about it... for that matter not that we are code inspectors does anyone know if there is a code dealing with gas fireplaces 
I think I would note it in the report that before, after & during using of the fireplace to inspect gas line coating for burnt or scorched coating. if it looks harmed in any stop using fireplace until having a licensed plumbing & heating person inspecting damages. |
To me they are more dangerous the having a BBQ inside .
At least BBQ inside is only for a short term these can be on all the time using up the oxygen in the home .
Why do you think is says in the directions to leave a window open when using.
--
Roy Cooke Sr.
http://Royshomeinspection.com
Originally Posted By: mtimpani
This post was automatically imported from our archived forum.
Do we light and test gas fireplaces?
–
Thank you, MarkTimpani
www.pridepropertyinspections.com
Originally Posted By: clawrenson
This post was automatically imported from our archived forum.
According to SOP - Fireplace II - D & E (Not Required)
2.8. Fireplace
I. The inspector shall inspect:
A. The fireplace, and open and close the damper door if readily accessible and operable.
B. Hearth extensions and other permanently installed components.
C. And report as in need of repair deficiencies in the lintel, hearth and material surrounding the fireplace, including clearance from combustible materials
II. The inspector is not required to:
A. Inspect the vent system.
B. Inspect the interior of the chimney or flue, fire doors or screens, seals or mantels.
C. Determine the need for a chimney sweep.
D. Operate gas fireplace inserts.
E. Light pilot flames.
F. Determine the appropriateness of such installation.
G. Inspect automatic fuel feed devices.
H. Inspect combustion make up devices.
I. Inspect heat distribution assists whether gravity controlled or fan assisted.
J. Ignite or extinguish fires.
K. Determine draft characteristics.
L. Move fireplace inserts, stoves, or firebox contents.
M. Determine adequacy of draft, perform a smoke test or dismantle or remove any component
--
Ontario Home Inspections Inc.