Courtesy of Reddit.
Month and a half after installation of the new water heater. Anyone care to list all the defects with this one?
My first question was were they trying to feed a water heater or a sub panel?
Courtesy of Reddit.
It’s amazing how many people don’t know how to properly install shims. Thin end-thick end-thin end-thick end etc.
6 Likes
No, I think you’re misunderstanding what you’re seeing here.
Julius “Pinhead” Schlabotka, Mighty Mouse’s biggest rival uses a shim gun. He finally was able to get Might Mouse. After the electricity cooked the poor little feller, all that was left was his family jewels.
I am fully aware of what was posted, sometimes it’s hard to read sarcasm.
1 Like
Plumber missed the mark installing this gas line just a teensy bit…
But hey, at least steel plates were installed…
Then out to the garage…
Through all of the trusses…
Then down the exterior wall…
7 Likes
Man, that is bad… 
4 Likes
It’s so unusual for a plumber to destroy framing like that. The patching with sheet metal is a nice touch.
3 Likes
I thought so too. 
Not sure why they routed the piping the way they did. The room where it ran through the floor was set up to be a laundry room. Couldn’t get below to see what else was going on.
2 Likes
That’s one of the reasons I don’t want them…upper denture.
I guess some of them look like that. 
2 Likes
Knock, knock…
4 Likes
You are inspecting the slums of a neighborhood somewhere?
2 Likes
One way to backfill the pool…
1 Like
Owner passed away & place has been vacant for 6 months.
It smelled pretty nasty inside.
The roof was in OK shape
4 Likes
Looks like Gene Hackman’s place
1 Like
The drain lines from both bathrooms went to an uphill line…. They never noticed but it’s easy to see even without the level.
8 Likes
1 Like