Wire Sheating

[system]

Originally Posted By: psmothers
This post was automatically imported from our archived forum.

---

Give me some feed back on this on guys.



It is my belief that the sheathing on the SEC cables is cut to high. They should below the plastic arc shield on the main correct?

Foxe Smothers

---

[system]

Originally Posted By: bbadger
This post was automatically imported from our archived forum.

---

No code violation here.


Not good looking work that is for sure.

---

--
Bob Badger
Electrical Construction & Maintenance
Moderator at ECN

[system]

Originally Posted By: jonofrey
This post was automatically imported from our archived forum.

---

Nice shiner!

---

–
Inspection Nirvana!

We're NACHI. Get over it.

[system]

Originally Posted By: Blaine Wiley
This post was automatically imported from our archived forum.

---

Either a Monday morning or Friday afternoon job. Knowhuttamean

---

[system]

Originally Posted By: jtedesco
This post was automatically imported from our archived forum.

---

Look at one of the early editions of the NEC between 1962-1971, and I think the section was 384-9? Something about leaving a 1/4 inch at the termination in a panelboard, other than that the guy or gal was probably in a hurry, and may have been a DIY or wannabe electrician!



---

--
Joe Tedesco, NEC Consultant

www.nachi.org/tedescobook.htm

[system]

Originally Posted By: psmothers
This post was automatically imported from our archived forum.

---

Thanks for the reply’s all.


Foxe Smothers

---